Ingco Automatic Pump Control WAPS001, 220-240V, 10bar Max
TSh 120,000
Our review
The Ingco WAPS001 is an automatic pump control unit that switches a water pump on and off based on pressure, so the pump runs when a tap opens and stops when it closes. It works on 220-240V at 50/60Hz, starts the pump at 1.5bar, tolerates up to 10bar, and draws a maximum of 10A. The IP65 rating means the enclosure is protected against dust and water jets, which matters for installations near tanks or outdoor pump housings. It suits households and small properties using a pressure pump for tank-to-house supply, where manual switching is inconvenient. Before buying, confirm your pump's voltage, running current and pressure range fit within these limits, and check the pipe connection size against your plumbing, since the unit is listed with a 1 x 1 pipe diameter. Compare it with other automatic controls on starting pressure, maximum pressure and current rating, and consider whether you need adjustable setpoints or dry-run protection, which this listing does not state. If your pump exceeds 10A or your system runs above 10bar, look at a higher-rated controller instead.
Sold and delivered by Sokonia. We may earn a commission when you buy through this link.